EnGenius 802.11b/g/n Access Point/Client Bridge/Repeater/Router WDS
- SKU: 79367
- Vendor: EnGenius
- UPC: 655216003804
Hardware Specification
MCU : RT2880, 266MHz
Memory : 32MB SDRAM
Flash : 8MB
Physical Interface : LAN: One 10/100/1000 Fast EthernetMbps, Reset Button, Power Jack, WPS push button (Wi-Fi Protected Setup)
LEDs Status : Power/ Status, LAN (10/100/1000Mbps), WLAN (Wireless Connection)
Power Requirements : Power Supply: 90 to 240 VDC 10% 50/60 Hz (depends on different countries), Active Ethernet (Power over Ethernet, IEE802.3af)- 48 VDC/0.375A, Device: 12V/1A
Regulation Certifications : FCC Part 15/UL, CE
RF Specification
Frequency Band : 2.400-2.484 GHz
Media Access Protocol : Carrier sense multiple access with collision avoidance (CSMA/CA)
Modulation Technology : OFDM: BPSK, QPSK, 16-QAM, 64-QAM / DBPSK, DQPSK, CCK
Operation Channels : 11 for North America
Receive Sensitivity (Typical) : IEEE 802.11n: MCS8 -91dBm MCS15 -74dBm / IEEE 802.11g (3RX): 6Mbps -92dBm 54Mbps -75dBm / IEEE 802.11b (1RX): 1Mbps -93dBm 11Mbps -91dBm
Available transmit power : IEEE 802.11n/g: 19dBm69 Mbps/MCS9, 18dBm1218 Mbps/MCS11,17dBm2436 Mbps/MCS13, 16dBm4854 Mbps/MCS15 / IEEE 802.11b: 18dBm1, 11Mbps
Antenna 3 : Omni-directional external antenna / TNC type :Peak Gain5dBi / Impedance: 50 ohm / Frequency Range: 0-6GHz / V.S.W.R. 1.5 (Max.) / Contact Resistance: Center contact: 1.5 Milliohms (Max.), Outer contact: 0.2 Milliohms (Max.)
Software Features
Topology : Infrastructure
Operation Mode : Client Bridge/Access Point/WDS AP/WDS Bridge/ Client Router/Router/Universal Repeater
LAN : DHCP Server . DHCP Client
Wireless Mode 11b/11g/11n/Disable
Channel Selection (Setting varies by Country)
Transmission Rate : 11b/g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1 in Mbps
Signal Strength
Bandwidth Selection - 40/20 MHz
Security
WEP Encryption-64/128 bit / WPA Personal (WPA-PSK using TKIP or AES) / WPA Enterprise (WPA-EAP using TKIP)
802.1x Authenticator / 802.1x Supplicant-MD5/TTLS (CB and CR mode)
Hide SSID in beacons / Multiple SSID with 802.1q VLAN tagging (up to 4 SSIDs) in AP mode
MAC Filter (AP mode) / WLAN L2 isolation (AP mode)
Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics)
Management
Configuration : Web-based configuration (HTTP)/Telnet
Firmware : Upgrade firmware via web-browser, Keep latest setting when f/w update
Administrator Setting : Administrator password change
Reset Setting : Reboot Reset to Factory Default
System monitoring : Status, Statistics and Event Log
SNMP : v1, v2c
MIB MIB I, MIB II (RFC1213) and Private MIB
Dimensions : L: 4.92" (125mm) x W: 4.25" (108mm) x H: 1.22" (31mm)
